Most of the time, companies will spend a lot of money to buy their lift trucks. It is essential, therefore to take good care of your machinery to protect your investment into the long run. It is really a good idea to know the procedures that are carried out in taking care of and maintaining this machinery.
By starting up the forklift and listening carefully how it works is among the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the machine is defective and this must raise several issues. What's more listen closely for any squealing sounds that come from the belts since these sounds would provide you with a lot of information.
Several of the main parts needing attention during maintenance include the gauges, horn, safety warning devices, the overhead guard and the lights. Any burnt out light bulbs or faulty components need to be replaced as soon as they are noticed. It is also vital to inspect the wiring.
After the above parts have been inspected carefully, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each cell of the battery should be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been done and new filters have been fitted, visually inspect the drive axle from underneath the equipment. Be certain to grease the axle if there is any grease fitting. Inspect the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Afterwards, check each and every other component of the machinery like the wheels. If any kind of fault or problem is detected, be certain to deal with it immediately so as to make certain the machine is running at its safest and optimum levels.